dry seal clamp Shiny for EH models

dry seal clamp shiny EH has the advantage of being able to be replaced by any other relief stamp pliers shiny EH of the different sizes and shapes available since they are made of very solid steel. The exchange is done in just a few seconds thanks to its fixing system to the lever. Just press to pop out the installed caliper and install the new one. Thanks to its reinforced design, it ensures long durability, quality and rigidity.

The great advantage of dry seals Shiny EH is that they accept the exchange of sets of clips of different sizes and designs. That is, with a single lever we can use as many different clamps as we want. Available sizes are 50mm diameter and 50x50mm square.

Dry seal clamp replacement process shiny HEY.

1.- Place the lever Shiny on a clear, firm surface such as a table.

2.- Press the embossed seal clamp with two fingers shiny EH to join the two parts of the engraved plate and thus remove the clamp from the notches that the lever has. Once unlocked, all you have to do is pull the clip outwards. If you have followed these steps now the gripper should be out of its marked position.

3.- Hold the new relief marking clamp to be installed with your fingers and press it to bring both plates closer to each other. The clamp has some hooks at the bottom that must coincide with the bar that has the lever in the caliper housing. Keep in mind that the position must be correct, otherwise it will not be possible to install the dry seal clamp shiny Uh properly.

4.- Gently push the dry seal clamp shiny for EH models until its correct housing. Check that the notches on the lever have been inserted into the holes in the caliper on the bottom plate. Now your stamp is ready to be used and make thousands of markings on paper or cardboard.

All embossed stamp models Shiny EH have a range of replacement collets with different sizes and shapes. So we can have several clamps for a single pincer and interchange them. Consult the section Accessories for dry stamps.

IMPORTANT:

Keep in mind the importance of determining the position of the markup in the document. Once mounted it cannot be modified. Understand that a embossed stamp selected to mark the bottom margin would be inverted if we eventually used it to mark the top margin.

You must take into account the approximate weight of the paper to be marked, since the recording of the plate is made with greater or lesser depth depending on the support to be marked. For example, if a thick paper is chosen, the engraving will be correct for that type of paper, but the same stamp used on paper with a lower grammage could perforate it.